Advertisement
- Follow your country's rules for the separate
collection of electrical and electronic products
and rechargeable batteries. Correct disposal
helps prevent negative consequences for the
environment and human health.
Removing the rechargeable battery
Only remove the rechargeable battery when
you discard the product. Before you remove
the battery, make sure that the product is
disconnected from the wall socket and that
the battery is completely empty.
Take any necessary safety precautions when
you handle tools to open the product and
when you dispose of the rechargeable battery.
1
Check if there are screws in the back or front of
the appliance. If so, remove them.
2 Remove the panel above the zoom wheel to
reach the screws of the appliance with a
screwdriver. If necessary, also remove
additional screws and/or parts until you see the
printed circuit board with the rechargeable
battery.
3 Remove the rechargeable battery.
- 该表格中所显示的"有害物质"在产品正常使用情况
下不会对人身和环境产生任何伤害。
- 该表格中所显示的"有害物质"及其存在的部件向消
费者和回收处理从业者提供相关物质的存在信息，
有助于产品废弃时的妥善处理。
Warranty and support
If you need information or support, please visit
www.philips.com/support or read the
international warranty leaflet.
Warranty restrictions
Cutting units are not covered by the terms of the
international warranty because they are subject to
wear.
Troubleshooting
This chapter summarizes the most common
problems you could encounter with the product. If
you are unable to solve the problem with the
information below, visit www.philips.com/support
for a list of frequently asked questions or contact
the Consumer Care Center in your country.
Problem
The
appliance
does not
work.
I cannot
switch off
the vacuum
system.
The vacuum
system
performs
poorly or
does not
work at all.
产品
：飞利浦胡须造型器
型号
：BT7501
额定电压 ：220V～
额定频率 ：50Hz
额定输入功率：9W
生产日期 ：请见产品本体
产地
：中国广东广州
飞利浦（中国）投资有限公司
上海市静安区灵石路718号A1幢
全国顾客服务热线: 4008 800 008
本产品根据国标 GB4706.1-2005,
GB4706.9-2008制造
Possible
cause
The battery is
empty.
The vacuum
system is
automatically
deactivated
when the
appliance is
switched off.
It is activated
automatically
as soon as
you switch on
the
appliance.
The hair
chamber is
full.
The air holes
on the
appliance are
covered. If
they are,
vacuum
performance
is reduced.
Solution
Charge the
appliance for at
least 1 hour so the
appliance has
enough power
again.
Switch off the
appliance.
Empty the hair
chamber after each
trimming session.
First remove the
cutting unit from
the appliance, then
empty the hair
chamber by
carefully shaking or
blowing hair out
and/or by brushing
the hair out with
the cleaning brush
or cleaning sponge
supplied. Never
use water to clean
the hair chamber,
this may damage
the appliance.
Make sure the air
holes on the
appliance are not
covered.
If the suction
system performs
poorly or not at all,
even though the
appliance is clean,
not covered and
used according to
the instructions in
the user manual,
take the appliance
to your local Philips
dealer or call the
Consumer Care
Center.
IPX4
Advertisement
