KitchenAid KDTE204EPA User Instructions page 10

OPTION SELECTIONS
OPTIONS
Dries dishes with heat and
a fan. This option with the
use of rinse aid will provide
the best drying
performance. Plastic items
are less likely to deform
when loaded in the top
rack. Turn ProDry™ option
off for an air dry.
Dries dishes with heat.
This option with the use of
rinse aid will provide the
best drying performance.
Plastic items are less likely
to deform when loaded in
the top rack. Turn Heat Dry
off for an air dry.
Runs the dishwasher at a
later time or during off-
peak electrical hours.
Select a wash cycle and
options. Press the Delay
or
button. Press START/
RESUME. Close the door
firmly.
NOTE: Anytime the door is
opened (such as, to add a
dish), the Start/Resume
button must be pressed
again to resume the delay
countdown.
Avoids unintended use of the dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The Control
Lock light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button
while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the
controls are locked.
or NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL, or by opening and
closing the door before you are able to turn Control Lock off.
To turn off Control Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The
light turns off.
NOTE: If your model requires you to press and hold 4 HOUR DELAY to lock the controls, the Control Lock LED will be
on or off to indicate if Control Lock is active or not.
CONTROLS AND CYCLE STATUS
CONTROL PURPOSE
To start or resume a
wash cycle
10
CAN BE WHAT IT DOES
SELECTED WITH
Available with any Uses the heating
element to heat air,
cycle except Rinse
plus a system of
Only
vents and a fan that
ventilates moist air
out of the
dishwasher to
speed drying times.
ProDry™ option
defaults to ON
when any cycle is
selected except for
1 Hour Wash.
Available with any Activates the
heating element at
cycle except Rinse
the end of the wash
Only
cycle to speed
drying times. Heat
Dry defaults to ON
when any cycle is
selected except for
1 Hour Wash.
Available with any Delays the start of a
cycle to the
cycle
specified time
COMMENTS
If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the door is closed and START/RESUME is pressed.
NOTE: If the Start/Resume button is located on top of door, push door firmly closed within
3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds, the
Start/Resume button LED will flash, an audible tone will be heard, and the cycle will not
start.
ADDED TIME TO CYCLE
TYPICAL MAX
44
52
240
.
ADDED
WATER
GALLONS
(LITERS)
51 0
52 0
480 0