Table of Contents
Advertisement
Available languages
Available languages
OPERATION
WARNING: To reduce the risk of serious personal injury,
place the forward/reverse button in the lock-off position or
turn tool off and disconnect battery pack before making any
adjustments or removing/installing attachments or accessories.
Installing and Removing the Battery Pack
(Fig. 3)
NOTE: Make sure your battery pack is fully charged.
FIG. 3
To install the battery pack (F) into the tool handle, align the battery with
the rails inside the tool's handle and slide it firmly into the handle until
you hear the lock snap into place.
To remove the battery pack from the tool, press the release button (E)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
Variable Speed Trigger Switch (Fig. 2)
To turn the tool on, squeeze the trigger switch (A). To turn the tool off,
release the trigger switch. Your tool is equipped with a brake. The
chuck will stop when the trigger switch is fully released. The variable
speed switch enables you to select the best speed for a particular
application. The more you squeeze the trigger, the faster the tool will
operate. For maximum tool life, use variable speed only for starting
holes or fasteners.
NOTE: Continuous use in variable speed range is not recommended.
It may damage the switch and should be avoided.
Forward/Reverse Control Button (Fig. 2)
A forward/reverse control button (B) determines the direction of the
tool and also serves as a lock off button. To select forward rotation,
release the trigger switch and depress the forward/reverse control
button on the right side of the tool. To select reverse, depress the
forward/reverse control button on the left side of the tool. The center
position of the control button locks the tool in the OFF position. When
changing the position of the control button, be sure the trigger is
E
released.
NOTE: The first time the tool is run after changing the direction of
F
rotation, you may hear a click on start up. This is normal and does
not indicate a problem.
Worklights (Fig. 2, 4)
There are three worklights (G) located around the chuck collar (C) or
anvil (J). The worklights will be activated when the trigger switch is
squeezed.
10
FIG. 4
G
G
Advertisement
Table of Contents
