Technical Data - AEG L88689FL User Manual

Problem
The appliance fills
with water and
drain immediately.
The washing re-
sults are not satis-
factory.
The drum is empty
and the display
shows there is
some weight in (J).
The drum is full
but the display
shows 0.0 kg (J).
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.
SERVICE
We recommend that you write the in-
formation here:
Model
(MOD.)

TECHNICAL DATA

Dimensions
Possible cause
The end of the drain
hose is too low.
The detergent you used
was not sufficient or cor-
rect.
You did not remove the
stubborn stains before
you wash the laundry.
Incorrect temperature
was set.
Too much laundry load.
It is necessary to set a
tare.
You loaded the laundry
before to activate the
appliance.
..................
Width / Height / Depth
Possible solution
Make sure that the drain hose is
in the correct position.
Increase the detergent quantity
or use a different one.
Use special products to remove
the stubborn stains.
Make sure that you set the cor-
rect temperature.
Decrease the laundry load.
Press button
the appliance and to activate it
again.
Press button
the appliance. Empty the drum
and obey to the necessary steps.
(Refer to 'Loading the laundry')
If the display shows other alarm codes,
contact the service centre.
• Refer to the information supplied
with this appliance for guarantee
condition and point of contact. The
information to give to the service is
on the rating plate.
Product number
(PNC)
Serial number
(S.N.)
ENGLISH 27
1 to deactivate
1 to deactivate
..................
..................
600 / 850 / 605 mm