JVC Everio R GZ-RX645 Detailed User Manual page 26

Recording
Operation Buttons for Still Image Recording
.
Operation
Buttons
Video/Still Image
A
Mode
A/B
WT Zoom
B
Still Image
C
Recording A
Playback Mode
D
MENU
E
Display Button n
F
Recording Mode
G
P/H
26
Description
Switches between video and still image
modes.
Allows the same functions as the zoom
lever to be performed.
Camera shake that often occurs when
using the zoom lever can be minimized.
"Zooming" (A p. 27)
Allows you to take still images using the
touch panel. Pressing and holding the
button allows you to adjust the focus before
shooting.
"Start recording after adjusting the focus"
(A p. 24)
Switches to the playback mode.
Displays the various menus of still image
recording.
"Operating the Menu" (A p. 144)
Switches the display between full (m) and
simple (n) with every tap of the button.
Simple display: Some displays
0
disappear automatically when the
screen is not operated.
Full display: Displays everything. The
0
display button changes from n to m.
When the power is turned off, simple
0
display (n) will be set.
Switches between the P Intelligent Auto
and H Manual recording mode.
Using the Silent Mode
When the Silent mode is used, the LCD monitor darkens and operation
sounds will not be output. Use this mode to record quietly in dark places such
as during a performance.
T appears when "SILENT MODE" is set to "ON".
0
To mute only the operating sound, set "OPERATION SOUND" in the menu
0
to "OFF" instead of using the silent mode.
" OPERATION SOUND " (A p. 157)
Operating procedure
o
A Tap "MENU".
The top menu appears.
0
B Tap T.
.
C Tap "ON".
.
Caution :
Do not expose the lens to direct sunlight.
0
While this unit may be used with the LCD monitor reversed and closed,
0
the temperature rises more easily. Leave the LCD monitor open when
using this unit for long periods of time, or in places exposed to direct
sunlight or high temperatures.
The power may turn off to protect the circuit if the temperature of this unit
0
rises too much.
Do not remove the AC adapter or SD card when the POWER/ACCESS
0
lamp is lighted. The recorded data may become unreadable.
This unit is a microcomputer-controlled device. Electrostatic discharge,
0
external noise and interference (from a TV, a radio, etc.) might prevent it
from functioning properly. In such a case, close the monitor screen to turn
off the power and remove the AC adapter, then press the Reset button to
reset this unit.
"Resetting this Unit" (A p. 6)
Memo :
Before recording an important scene, it is recommended to conduct a trial
0
recording.
Depending on the shooting conditions, the four corners of the screen may
0
appear dark, but this is not a malfunction. In this case, change the shooting
conditions by moving the zoom lever, etc.