Pulling Up The Bobbin Thread - Brother CS-8070 Operation Manual

S2_brotherE.book Page 29 Thursday, February 13, 2003 11:03 AM

Pulling up the bobbin thread

When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
1 Insert the bobbin into the shuttle.
1
• Refer to steps
bobbin" (page 16).
2
Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
3 While lightly holding the upper thread with
your left hand, press
button) twice to raise the needle.
1
1 Needle position button
The bobbin thread is looped around the
upper thread and can be pulled up.
4 Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
5
through of " Installing the
(needle position
5 Pull out about 10-15 cm (3/8-5/8 inch) of the
bobbin thread under the presser foot toward
the rear of the machine.
6 Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
1
Upper Threading
1
2
29