Table of Contents
Advertisement
26
Problem
The compressor does not
start immediately after press-
ing the IntensiveCooling, or
after changing the tempera-
ture.
Water flows on the rear plate
of the refrigerator.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
Possible cause
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The NO REFERENCE TO
FREEZING FUNCTION or
IntensiveCooling function is
switched on.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The IntensiveCooling func-
tion is switched on.
There is no cold air circula-
tion in the appliance.
Solution
The compressor starts after a
period of time.
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off NO REFERENCE TO
FREEZING FUNCTION or In-
tensiveCooling manually, or
wait until the function resets
automatically to set the temper-
ature. Refer to "NO REFER-
ENCE TO FREEZING FUNC-
TION or IntensiveCooling func-
tion".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "IntensiveCooling func-
tion".
Make sure that there is cold air
circulation in the appliance.
Advertisement
Table of Contents
