BR Remote Camball 4Ki Instruction Information page 9

1
The Profile of each move is stored with each position. Fig.2 illustrates that each move TO a
pre-set position will take the time associated with that end position.
enables efficient use of the same start position.
8
Fig.3 illustrates the opposite situation to Fig.2. Because each of these moves ends with
position 1, each move will take the same amount of time – as defined by the profile associated
with position 1. Therefore, the move from position 8 will be the fastest.
If the move is taking too long the operator simply needs to push the pre-set position button
again and the camera will reposition as fast as possible.
The camera will make the profile move from wherever it is to the pre-set position selected,
always in the same amount of Time. Therefore, the camera will move faster if the move is
further.
To perform the same move repeatedly use 2 pre-set positions. 1 for the start position and 1 for
the end position.
D* Commands for the Camball4
The position of any axis can be requested from the camera. This is useful if you are not using a
virtual model of the Camball4Ki and need to generate your own reference positions.
If you need to write your own control commands please ask
Mstar Protocol documents including the full command list.
3
6
7
4
- 9 -
Fig. 2
5
Understanding this
Fig. 3
1
BR Remote for the full Dstar &