Connections - BR Remote Camball 4Ki Instruction Information

Connections

Dstar data from a BR Remote control desk is connected normally via the XLR4 input socket.
There is an additional 9pin Dsub on the base of the camera. This outputs Metadata and
accepts other types of control data.
selected from the Setup menu.
DMX, Mstar and Free-D data is input on this
Dsub connector.
Once you have selected the Protocol the
menu will request further settings.
Selecting DMX will then prompt for the DMX
Base Address.
Selecting Free-D will prompt for Angular or
RAW data.
Mstar has no further options.
9 Pin Dsub
• Pin 1 -
GND
• Pin 2 -
RS422/485 Ch.A – Metadata output
• Pin 3 -
RS422/485 Ch.B – DMX, Mstar or Free-D input
• Pin 4 -
Do not connect
• Pin 5 -
Do not connect
• Pin 6 -
No connection
• Pin 7 -
RS422/485 Ch.B – Metadata output
• Pin 8 -
RS422/485 Ch.A – DMX, Mstar or Free-D input
• Pin 9 -
Do not connect
These pins are the standard pins for RS422 connection and can be directly connected
to other equipment with a suitable cable.
Both a DMX input cable and a Free-D input/output cable are supplied with the Camball4
XLR4
• Pin 1 -
• Pin 2 -
• Pin 3 -
• Pin 4 -
This is
GND
RS485 Data A
RS485 Data B
+10 – 16v (nominally 12v)
AUX data and the
Blue
Green
Yellow
Red
- 6 -
AUX Protocol can be