Table of Contents
Advertisement
OPERATION
Detergent
C A U T I O N
Use only approved pressure washer cleaners. Do not use bleach, chlorine,or any cleaners
containing acids.
To use:
• Connect low pressure black soap spray tip to the wand connector.
• Squeeze the trigger and the detergent will automatically be mixed with the water and dispensed
from the spray tip.
NOTE: Use a funnel, if needed, to prevent accidental spilling of the detergent outside the tank.
If any detergent is spilled during the filling process, make sure the unit is cleaned and dried
before proceeding.
STARTING AND STOPPING THE PRESSURE WASHER
C A U T I O N
Do not run the pump without the water supply connected and turned on.
•
Connect the garden hose.
•
Turn the water supply on, then squeeze the trigger and run water hose with motor in OFF
position until a steady stream of water appears. This helps drain air from tank and lines.
NOTE: If the pressure washer pulsates and the water stream is intermittent turn the pressure
washer off and continue to bleed air out of the system. Ensure to check that the garden hose is
fully turned on and not kinked.
•
After ensuring the On/Off switch is in the OFF ( O ) position, connect the pressure washer
to the power supply.
•
Press the reset button on the pressure washer's plug to make sure the unit is ready for
operation.
Use Black Soap Tip Only
Tank
18
See Figure 13.
Fig. 12
Advertisement
Table of Contents
