Mounting The Rear Speakers - Yamaha NS-P610 Owner's Manual

Mounting the rear speakers

1
2
4
E-
Bracket
Screw
Pads
Tapping screw (4–5 mm)
(Available at the hardware
store)
Min.
20 mm
2 mm
40 mm
Mount the rear speakers on a shelf, rack or directly on the
floor, or hang them on the wall.
To mount the rear speakers on a wall by
using the provided mounting brackets
1
Attach the bracket to the rear of the speaker by using
the provided screws. Remove the provided pads from
the backing sheet and put them at the lower corners of
the speakers.
2
Fasten screws into a firm wall or wall support as shown
in the figure, and hang the holes of the mounting
bracket on the protruding screws.
* Make sure that the screws are securely caught by the
narrow parts of the holes.
WARNING
● Each speaker weighs 1.5 kg (3 lbs. 5 oz.). Do not
mount them on thin plywood or a wall with soft
surface material. If mounted, the screws may come
out of the flimsy surface and the speakers may fall.
This damages the speakers or causes personal
injury.
● Do not install the speakers to a wall with nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause them to fall.
● To avoid accidents resulting from tripping over loose
speaker cords, fix them to the wall.
You can also use the screw holes on the bottom of the
speaker for installing the speakers on commericially
available speaker stands (if you do not use the provided
mounting brackets.)
60 mm
A screw with a diameter of 4 mm can
be used.
(Hole depth : 8 mm)