Appendix
Cleaning, removing and re-installing
PC adjustable glass tray
Removing
Lift up the back of the tray until the
1
protrusions of the PC adjustable glass
tray are unhooked from the rails.
Pull it forward.
2
Tilt the tray and remove it.
3
Attaching
Push the tray until it reached the end
lock.
Attention
●When removing the tray above the vegetable case, please pull out the vegetable case
fi rst and then follow to removing the tray as above details.
●Trays are made of glass and heavy.
Please handle them with care so that they do not fall and cause any damage or injury.
For attaching trays, hold them with the protrusion side down and fi rmly insert.
Door shelf/Bottle shelf
Removing
Tap the bottom of the small shelves
upward or slide alternately the left and
right of the big shelves upward, and
raise them slowly. (Tightly attached)
Slide the shelves
upward.
Vegetable case
Removing
Pull the case unit forward until it
1
reaches the end of the stopper.
Lift the front of the case unit slightly
2
and remove completely.
2 2 2
1 1 1
18
ARAH0A106620_EN.indd 18
ARAH0A106620_EN.indd 18
Once every 3 months
1 1 1
2 2 2
Rail
Once every 3 months
Attaching
Set each shelf horizontally, with the
mark [>PS<] on the right, and push it
down to its proper position.
Once every 3 months
Attaching
Insert the case unit into the supports.
1
Raise the case unit up slightly and
2
push forward until the end is reached.
2 2 2
1 1 1
Introduction
Protrusion
3 3 3
5/22/2562 BE 14:11
5/22/2562 BE 14:11