Adding Laundry; Changing The Programme; Cancel The Programme; Programme End During Rinse Hold - Bosch WAW28790IN/15 Instruction Manual And Installation Instructions

Adding laundry

After starting the programme, you can
add or remove laundry if necessary.
Press the A button to do this.
The A button indicator light will flash
and the machine will check whether it is
possible to add laundry.
If
Both the - P - and ÿ symbols light
■
up on the display panel, it is possible
to add laundry.
- P - lights up, it is not possible to
■
add laundry.
To resume the programme, press the
A button.The programme will resume
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, while the drum
is turning or during the active oxygen
phases, and it is not possible to add
laundry during this time.
It is not possible to add laundry
■
during the Active Oxygen Refresh Ø
programme or when the Active
Oxygen Ø setting has been
selected.
The load indicator is not active
■
during reloading.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Press the A button.
1.
Select another programme.
2.
Press the A button. The new
3.
programme starts from the
beginning.
Operating the appliance
When switching from
Note:
programmes that use active oxygen to
those that do not, the door will remain
locked for up to 25 minutes until there
is no longer any active oxygen in the
drum.
The ÿ and Ø symbols will flash. If the
symbols are off, the door can be
opened.

Cancel the programme

For programmes at high temperatures:
Press the A button.
1.
To cool down laundry:
2.
Select ' Rinse.
Press the A button.
3.
For programmes at low temperatures:
Press the A button.
1.
Select 0 Spin or [ Drain .
2.
Press the A button.
3.
When cancelling programmes
Note:
that use active oxygen, the door will
remain locked for up to 25 minutes until
there is no longer any active oxygen in
the drum.
Switch the appliance on again if
necessary. The ÿ and Ø symbols will
flash. If the symbols are off, the door
can be opened.
Programme end during rinse
hold
In the display panel, $ flashes, and the
preset spin speed and remaining
programme length are displayed for the
selected programme.
Continue the programme by:
Pressing the A button or
■
Changing the spin speed, or setting
■
the programme selector to [ Drain
and then pressing the A button.
en
37