Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may be
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow is
at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Connection
Connect the water supply hose to the
water tap (¾" = 26.4 mm) and to the
appliance (not necessary for Aqua-Stop
models as this is permanently installed):
Model: Standard
■
Model: AquaSecure
■
Model: Aqua-Stop
■
Positioning and connecting
Open the water tap carefully,
Note:
checking the leak tightness of the
connection points. The screw
connection is under mains water
pressure.
Water outlet
:
Warning
Risk of scalding!
When washing at high temperatures,
there is a risk of scalding if you come
into contact with hot detergent solution
(e.g. when draining hot detergent
solution into a washbasin).
Do not reach into the hot detergent
solution.
Caution!
Water damage
When water is being pumped away, the
outlet hose is under water pressure and
may slip out of the wash basin or
connection point.
Secure the outlet hose so that it cannot
slip out.
Caution!
Damage to the appliance/fabrics
If the end of the outlet hose is immersed
in the drained water, water may be
sucked back into the appliance and
may damage the appliance/fabrics.
Make sure that:
The plug does not block drainage
■
from the wash basin.
The end of the drain hose is not
■
immersed in the drained water.
The water drains away quickly
■
enough.
Do not kink the water drain hose
Note:
or stretch it lengthways.
Connection
Drainage into a siphon
■
The connection point must be
secured using a hose clamp with a
en
37