Acer B248Y User Manual page 31

System
Picture Input
Color
Auto Source
Audio
Daisy Chain
Pertormance
Wide Mode
OSD
Hot Key Assignment
System
DDC/CI
ProxiSense
Rest Reminder
Save Settings to...
Move Enter
HDMI Black Level
Picture
Quick Start Mode
Color
USB Port Select
Audio
USB 3.0
Power-off
Pertormance
USB change
OSD
System
Save Settings to...
Move Enter
1. Press the MENU key to open the OSD.
2. Toggle the joystick to the up or down to select System from the OSD.Then toggle to the
right to navigate to the element you wish to adjust and press the joystick to enter it.
3. Toggle to the left or right to adjust the sliding scales.
4. Input: Select the source
5. Auto Source: The default is "On", which can support auto search for signal source in
order.
----------------------------------------------------------------------------------------------------------
Note: Surround application must set Auto Source is "Off".
6. Daisy Chain: Default is Off, can select daisy chain function Extend or Clone. Clone
mode is not supported with AdaptiveSync.
7. Wide mode: You can select which screen aspect you are using. The options are
Aspect, Full, 1:1 and 21:9.
8. Hotkey Assigment: Hot Key 1 and Hot Key 2 can't repeat the same function. Hot Key
1 default is (Modes), Hot Key 2 default is (Brightness). Because some functions limit
the Hot Key to be gray out and unavailable. Hot Key can define of: (Modes, Brightness,
Volume, Gamma, Contrast, Low Blue Light, Over Drive).
9. DDC/CI: Allows the monitor settings to be set through the software on the PC.
-----------------------------------------------------------------------------------------------------------
Note: DDC/CI, short for Display Data Channel/Command Interface, which allows
Mode - Standard
HDMI
On
Off
Full
On
Off
Off
Mode - Standard
Normal
Off
C-Type
Off
Off
from HDMI ,DP or DP
X
X
ALT.