Table of Contents
Advertisement
that some other form of authorization or testing may be required for the finished
device.
OEM END PRODUCT USER MANUAL STATEMENTS
The OEM integrator should not to provide information to the end user regarding
how to install or remove this RF module or change RF related parameters in the
user manual of the end product.
If this module is intended for use in a portable device, you are responsible for
separate approval to satisfy the SAR requirements of FCC Part 2.1093.
The user manual for the end product must include the following information in a
prominent location:
This device is granted for use in Mobile only configurations in which the antennas
used for this transmitter must be installed to provide a separation distance of
at least 20cm from all person and not be co-located with any other transmitters
except in accordance with FCC and Industry Canada multi-transmitter product
procedures.
The end product with an embedded FCC ID:ORP-IBT-03 Module may also need to pass
the FCC Part 15 unintentional emission testing requirements and be properly
authorized per FCC Part 15.
The labeling instructions of finished products refer to following requirements:
A certified modular has the option to use a permanently affixed label, or an
electronic label (see Electronic Labelling below). For a permanently affixed label,
the module must be labelled with an FCC ID - Section 2.926 (see Certification
(labelling requirements) above). The OEM manual must provide clear instructions
explaining to the OEM the labelling requirements,options and OEM user manual
instructions that are required (see next paragraph).
For a host using a certified modular with a standard fixed label, if (1) the module'
s FCC ID is not visible when installed in the host, or (2) if the host is marketed
so that end users do not have straightforward commonly used methods for access
to remove the module so that the FCC ID of the module is visible; then an additional
permanent label referring to the enclosed module:
"Contains Transmitter Module FCC ID: ORP-IBT-03" or "Contains FCC ID: ORP-IBT-03"
must be used. The host OEM user manual must also contain clear instructions on
how end users can find and/or access the module and the FCC ID.
Other user manual statements may apply.
Advertisement
Table of Contents
