What To Do If - Zanussi ZBA14441SC User Manual

2. Remove any stored food, wrap it in several
layers of newspaper and put it in a cool
place.
3. Leave the door open.
4. When defrosting is completed, dry the in-
terior thoroughly and refit the plug.
5. Switch on the appliance.
6. Set the temperature regulator to obtain the
maximum coldness and run the appliance
for two or three hours using this setting.
7. Reload the previously removed food into
the compartment.
Important! Never use sharp metal tools to
scrape off frost from the evaporator as you
could damage it. Do not use a mechanical
device or any artificial means to speed up the
thawing process other than those

What to do if...

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Only a qualified electrician or competent
person must do the troubleshooting that is not
in this manual.
Problem
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
The compressor operates
continually.
18
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set correct-
ly.
The door is not closed correctly.
The door has been opened too fre-
quently.
recommended by the manufacturer. A
temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Periods of non-operation
When the appliance is not in use for long peri-
ods, take the following precautions:
• disconnect the appliance from electric-
ity supply
• remove all food
• defrost (if foreseen) and clean the appliance
and all accessories
• leave the door/doors ajar to prevent un-
pleasant smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food in-
side from spoiling in case of a power failure.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Solution
www.zanussi.com