Dometic PerfectView M70IP Installation And Operating Manual page 19

PerfectView M70IP
• When laying the cables (fig. 3, page 3), make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection.
Connecting the monitor as a reversing video system (fig. d, page 7)
➤ Lay the connection cable on the dashboard.
➤ Insert the plug of the monitor cable (2) into the socket (4) of the connection cable (3).
A
NOTICE! Beware of damage!
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cable to a suitable voltage supply:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤ If the monitor is to be activated when reverse gear is selected, connect the green cable (7) to
the positive cable of the reversing light.
I
NOTE
If voltage is present in the green cable (7), the reversing camera will be activated
automatically. The reversing camera has priority.
➤ If the monitor is to be activated by actuating the indicator, for example, connect the white
control cable (8) to a positive cable of the indicator.
I
NOTE
If voltage is present in this control cable, the video input CAM2 will be activated.
This control cable is used as a signal cable for the activation of a side camera when an indicator is
flashing, for example.
➤ If necessary, connect the CAM1 socket (9) of the connection cable to the plug of video
source 1 (e.g. camera).
➤ If necessary, connect the CAM2 socket (10) of the connection cable to the plug of the video
source 2 (e.g. side camera).
➤ If necessary, connect the CAM3 socket (11) of the connection cable to the plug of video
source 3 (e.g. reversing camera).
I
NOTE
Observe the power consumption of the video system. The cameras are equipped with
heaters. A maximum current of 1.5 A can flow (three cameras in heating mode). Use a
disconnector switch for direct connection to the battery. This allows you to disconnect
the video system from the battery easily if you are no longer using the vehicle.
EN
Installing the LCD monitor
19