Sherwood R-672 Operating Instructions Manual page 27

R-672(A) 2007.6.15 10:17 AM 페이지 27
Manual presetting
• You can store up to 30 preferred stations in the memory.
1.
Tune in the desired station with auto or manual tuning.
2.
Press the (MEMORY/) ENTER button.
• "MEM" is flickering for several seconds.
4.
Repeat the above steps 1 to 3 to memorize other stations.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned off, are memorized.
• INPUT SELECTOR settings
• Surround mode settings
• Preset stations,etc.
Tuning to preset stations
• After selecting the tuner as an input source, select the
desired preset number.
• When using the NUMERIC buttons on the remote control.
Examples) For "3" :
For "15" :
For "30" :
3.
Select the desired preset number (1~30) and press the
(MEMORY/)ENTER button.
• When using the NUMERIC buttons on the remote control.
Examples) For "3" :
For "15" :
For "30" :
• The station has now been stored in the memory.
• When using the NUMERIC buttons, the station is stored
automatically without pressing the (MEMORY/)ENTER
button.
• A stored frequency is erased from the memory by
storing another frequency in its place.
• If "MEM" goes off, start again from the above step 2.
Scanning preset stations in sequence
• The receiver will start scanning the stations in the
preset sequence and each station is received for 5
seconds.
• At the desired station, press this button again to stop
scanning.
27