Care And Cleaning - AEG LAVATHERM 67680IH3 User Manual

16 www.aeg.com
10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the
Drying buttons.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the
again and again until you set
necessary degree.
6. To memorise the setting, push at the
same time the
Time Drying buttons for
approximately 2 seconds.
10.3 Deactivating the Tank
indicator
The water container indicator is by
default on. It starts to light at the end of

11. CARE AND CLEANING

11.1 Cleaning the filter
At the end of each cycle the indicator
Filter is on and you must clean the filter.
The filter collects the fluff.
The fluff occurs while the
cloths are dried in the
tumble dryer.
Anticrease and Time
Start/Pause button
Anticrease and
the drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and indicator can be
permanently off.
To deactivate the indicator:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Anticrease and
Delay Start buttons.
One of 2 configurations is possible:
• the Tank indicator:
the symbol
view - the water container
indicator is permanently on
• the Tank indicator:
the symbol
view - the water container
indicator is permanently off
1. Open the door. Pull the filter.
is on and
goes into the
is off and
goes into the