Timer; Managing Camera Units - Panasonic KX-HN4001 Operating Instructions Manual

Table of Contents

Advertisement

R To enable detection for a disabled cell,
select the disabled cell. a MOKN
6
When finished, press M
repeatedly to exit.
Configuring the sound sensor
sensitivity
1
MMENUN
2
MbN: "Sensor Settings" a MOKN
3
MbN: "Sound Sensitivity" a MOKN
4
MbN: Select the desired setting. a MOKN
a MMENUN repeatedly to exit.

Timer

The timer can be used to play sound from the
monitor unit after the specified number of
hours has passed. The timer can be set to
sound once or repeat at specified intervals.
1
MMENUN
2
MbN: "Timer" a MOKN
3
MbN: Select "Once" or "Repeat". a
MOKN
4
MbN: Specify when the timer is set for. a
MOKN a MMENUN
Note:
R Timers play for 1 minute. Press MOKN to
stop a timer. Press and hold MOKN for
5 seconds to stop timers from repeating.
R If the monitor unit is turned off after setting
a timer:
– "Once": The timer will be canceled.
– "Repeat": The timer will be played once
the specified time has passed from when
the monitor was turned on again.

Managing camera units

Registering a camera unit
Monitor unit:
1
MMENUN
For assistance, please visit http://shop.panasonic.com/support
N a MMENUN
2
MbN: "Camera Management" a MOKN
3
MbN: "Add Camera" a MOKN
R An operation guide is displayed. Press
MOKN to continue.
R Complete the following step within
90 seconds.
Camera unit:
1
Press and hold M
the LED indicator starts blinking.
Note:
R A message is displayed on the monitor unit
to show if the registration was successful or
not, and a beep sounds.
Resetting a camera unit
The camera unit settings saved on a monitor
unit can be reset.
Note:
R All camera unit settings except for
registration settings are reset.
R Settings for all camera units registered to
the monitor unit are reset.
1
MMENUN
2
MbN: "Camera Management" a MOKN
3
MbN: "Reset" a MOKN
4
M
N: "Yes" a MOKN
R A beep sounds from the monitor unit
when resetting is completed.
Canceling a camera unit
Note:
R Only the currently connected camera unit is
canceled. To cancel other camera units,
select the displayed camera unit (page 21)
and then cancel that camera unit.
1
MMENUN
2
MbN: "Camera Management" a MOKN
3
MbN: "Delete Camera" a MOKN
4
M
N: "Yes" a MOKN
Programming
N for 3 seconds until
27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-hn4101Kx-hn4102X-hn1032Kx-hnc300Kx-hnm300Kx-hn1032

Table of Contents