Maintenance - Ryobi PBLID02 Operator's Manual

USING THE IMPACT DRIVER
See Figures 6 - 7, page 9.
NOTICE:
The impact driver is not designed to be used as a drill.
WARNING:
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a "live" wire will
make exposed metal parts of the tool "live" and possibly
shock the operator. If you must drive a screw where hid-
den wire may be present, always hold tool by insulated
gripping surfaces (handle) when performing the operation
to prevent a shock to the operator.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
LED LIGHT FUNCTIONS
TOOL STATUS
Normal
Low Battery
Excessive Force
Over Temperature
*More than 9 flashes will result in the need to remove the battery and reinsert a few minutes later.
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION

MAINTENANCE

TROUBLESHOOTING
LED LIGHT SCENARIO
Solid Light (No Flashes)
NOTE: ILLUSTRATIONS START ON PAGE 9
 Check the direction of rotation selector for the correct
setting (forward or reverse).
 Hold the impact driver with one hand.
 Place the bit on the screw head, bolt head, or nut and
slowly depress the switch trigger. Start the bit slowly for
more control.
 As the screw, bolt, or nut is driven, impacting will begin.
ELECTRIC BRAKE
The electric brake will stop the bit rotation after the operator
releases the switch trigger.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
3 Flashes
6 Flashes
9 Flashes
8 - English
ACTION REQUIRED
No Action Needed
Replace Battery
Wait 5 Seconds
Let Tool Cool Off