Install Range Hood - Elisa EPR628S1 Installation Instruction Manual

A
Cabinet Height Hole Shape and Size
12" (30.5 cm) A 6¼" deep x 8" wide (15.9 cm x 20.3 cm)
rectangular opening in the cabinet top is
required for damper transition clearance.
Complete Preparation
1. If not yet attached, install the 6" (15.2 cm) vent transition the
top of the range hood liner using two 3.5 x 9.5 mm screws.
2. Locate side mounting bracket flush 1 cm to the bottom of the
cabinet side and against the inside of the front cabinet face.
Orient the bracket depending on the width of your cabinet as
depicted in the diagrams below. Drill ⅛" (3 mm) pilot holes in
6 places, attach a bracket using three 4.5 x 13 mm screws to
each side of the cabinet, and tighten. Additional washers in
hardware package are supplied as spacers for cabinet walls
thinner than ½" (13 mm).
Bracket Orientation for 30" (76.2 cm) Cabinet
B
A
A. 30" (76.2 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
C.Washers (optional)
D. Mounting bracket (2) (position for 30" [76.2 cm] cabinet)
3. Install the vent system according to the method needed.
Use caulking to seal the exterior wall or roof opening.
B
C
A. Cutout
B. See chart below
C. 7¾" (19.7 cm) center-
line to cabinet front
D. Centerline
D
C
D
Move the bracket ⁄ " (1 cm) from the bottom
6
16
side of the cabinet

Install Range Hood

Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
1. Using 2 or more people, lift the hood liner into its mounted
location. Attach with four 4.2 x 19 mm screws into the slotted
openings. Do not tighten screws.
A
A.Cabinet
B.Hood liner canopy assembly
2. Center the canopy in the cabinet. Align the bottom of the
canopy with the bottom of the cabinet. Install four 4.2 x 19 mm
screws into the round mounting plate openings and tighten all
(8) mounting screws.
3. Remove the metal grease filters from the face panel. See the
"Range Hood Care" section.
Attach the face plate to the hood insert.
NOTE: If cabinet depth is greater than 12", it is recommended
that the two 1/2" metal spacers are installed.
Install to front and rear sides of the face plate with 3.5 x 9.5
mm screws as shown in drawing.
C
A
A.Face Panel
B.Front and rear spacer
9
WARNING
B
C
C. Screws - 4.2 x 19 mm (8)
C
B
C. Screws - 3.5 x 9.5 mm (4)