Service, Troubleshooting And Repair - SBI Splitz-it 5-Ton Operator's Manual

SERVICE, TROUbLESHOOTING AND REpAIR

SERVICE INFORMATION
IMpORTANT
IN CASE OF A SERVICE pRObLEM, DO NOT SEND UNIT
bACk TO RETAILER.
CONTACT SbI HEATING ACCESSORIES,
TELEpHONE: 1 418 878-3040
E-MAIL: tech@sbi-international.com
In the event you experience trouble operating your log splitter,
follow the suggestions in the troubleshooting guide in this
section.
The guide will help you pinpoint the causes of common
problems and identify remedies.
We will always be glad to answer any questions you have,
or help you find suitable assistance. To order parts or inquire
about warranty, see the section ordering repair parts.
TROUbLESHOOTING
pRObLEM
Fails to split logs
The log pusher moves with
a jerking motion, makes an
unfamiliar noise or vibrates
excessively
Oil leak occurs around cylinder
ram or from other points
contact service provider if above remedies fail.
10
pOSSIbLE CAUSE
1. Log is improperly positioned
2. The size or hardness of the log exceeds
the capacity of the machine
3. Wedge cutting edge is blunt
4. Oil leaks
5. Unauthorized adjustment was made onto
the maximum pressure limiting screw
1. Lack of hydraulic oil and excessive air in
the hydraulic system
1. Air sealed in hydraulic system while
operating
2. Bleed screw is not tightened before
moving the log splitter
3. Oil drain bolt with dipstick is not tight
4. Hydraulic control valve assembly and/
or seal(s) worn
Splitz-it 5-tON electric lOg Spliter
ORDERING REpAIR pARTS
Parts can be obtained from the store where your mini log
splitter was purchased.
Please include the following information with your order:
1. Part numbers
2. Part description
3. Quantity
4. Model number and serial number
REMEDY/ACTION
1. Refer to Log Splitter Operation Section for log
loading
2. Reduce the log size before splitting on the log
splitter
3. Refer to Sharpening Wedge Section to sharpen
the cutting edge
4. Locate leak(s) and contact the dealer
5. Contact the dealer
1. Check oil level for possible oil refilling. Contact
the dealer.
1. Loosen bleed screw 3-4 rotations before
operating the log splitter
2. Tighten the bleed screw before moving the
log splitter
3. Tighten the oil drain bolt with dipstick
4. Contact the retailer