LG WFT75A31EP Owner's Manual page 12

12
F
unction of each Button
WATER TEMPERATURE BUTTON (OPTION)
Use to select Water Temperature.
Pressing the button allows you to select
COLD WARM (HOT&COLD)
HOT COLD respectively.
Default setting is COLD.
WASH OPTION BUTTON(OPTION)
• According to kinds of
laundry, soiled extent or
washing habit you can
select suitable WASH
OPTION manually.
• By pressing the button
WASH OPTION is
changed.
(refer to page 22)
Note
* For optimizing the washing algorithm, the displaying time may be changed during washing-increased by
8minutes at maximum and decreased by 4 minutes at maximum.
* If the Detergent quantity is put more than the standard, for increasing the rinsing performance, it automatically
adds rinsing, and the remaining time may be increased.
* The standard detected by the sensor changing the algorithm is set by the normal standard. It may not be same to
the washing habit of a specific user. So, it does not matter that the user uses it according to her/his washing habit.
* The sensor for a Detergent quantity is designed to detect based on a synthetic Detergent powder. If you put a
liquid one or a natural one or too much bleaching agent, the detecting ability of the sensor may be decreased.
WATER LEVEL BUTTON
(INDICATION OF DETERGENT AMOUNT)
• Use to adjust the WATER LEVEL as required. The appropriate amount of
• WATER LEVEL is automatically selected for FUZZY (normal) program.
DELAY START (RESERVATION) BUTTON
• Use to set a delayed finishing time.
• The time increases when the button
is pushed.
• The following settings are indicated
as the button is pushed 3 4
...11 12 14 16 ...46
3 HOUR.
• To cancel delay time, turn the power
switch off.
(refer to page 20)
Detergent is shown next to the WATER LEVEL in the WATER-
DETERGENT diagram
The following settings are indicated as the button is pushed
LARGE . EX-LARGE
LARGE
SMALL MEDIUM MEDIUM
WASHING CONDITION INDICATOR
• It only operates in FUZZY Program.
• During being detected by the sensor, the LED flashes green, orange
and red in turn. And, after detecting, the LED lights a specific color
according to the detecting condition as follows:
If the current washing condition (Detergent quantity, Water
5
Temperature, water quality, etc.) is determined as better than the
standard one, it optimizes the algorithm to save the energy by
48
decreasing washing time/strength, and the LED automatically turns
to red.
If the current washing condition is determined as worse than the
standard one, it optimizes the algorithm by increasing washing
time/strength, and the LED automatically turns to orange.
If the current washing condition is determined as equal to the standard
one, the algorithm has no change and the LED turns to green.
EX-LARGE SMALL
MEDIUM LARGE LARGE