Table of Contents
Advertisement
Available languages
Available languages
INSTALL LEVELING LEGS
1.
Prepare dryer for leveling legs
To avoid damaging floor, use a large flat piece of cardboard
from dryer carton; place under entire back edge of dryer.
Firmly grasp dryer body (not console panel) and gently lay
dryer down on cardboard.
2.
Screw in leveling legs
Using a wrench and tape measure, screw legs into leg
holes until bottom of foot is approximately 13 mm (1/2")
(to match height of 0.102 m
38 mm (1½") (to match height of 0.108 m
washer) from bottom of dryer.
Now stand the dryer on its legs. Slide the dryer until it is
close to its final location. Leave enough room for electrical
connection and to connect the exhaust vent.
For mobile home use
Gas dryers must be securely fastened to the floor.
Mobile home installations require a Mobile Home Installation
Hold-down Kit. For ordering information, please reference
the Use and Care Guide.
8
[3.6 cu. ft.] capacity washer) or
3
[3.8 cu. ft.] capacity
3
GAS DRYER POWER HOOKUP
Gas Supply Requirements
Gas type
Natural gas:
This dryer is equipped for use with Natural Gas. It is design-
certified by CSA International for propane or butane gases with
appropriate conversion.
Your dryer must have the correct burner for the type of gas
n
in your home. Burner information is located on the rating
plate in the door well of your dryer.
Propane gas conversion:
Conversion must be made by a qualified technician.
No attempt shall be made to convert the dryer from the gas
specified on the model/serial rating plate for use with a different
gas without consulting the serving gas supplier.
IMPORTANT: The gas installation must conform with local codes.
Advertisement
Table of Contents
