Controlling Dome Cameras By Keyboard; Setting The Keyboard Parameters To Control Dome Camera - HIKVISION DS-1004KI User Manual

User Manual of the DS-1004K keyboard

3.2 Controlling Dome Cameras by Keyboard

Setting the Keyboard Parameters to Control Dome Camera

Before you start:
Check the connection between the keyboard and dome camera. The TA and TB interfaces of CON of keyboard should be connected to
the RA and RB interfaces of the dome camera respectively. The following figure shows the simplest way of connection between a
dome camera and keyboard.
Steps:
1. Turn the key to the MENU item, and press the Mode button to select PTZ.
2.
Enter the device number. E.g. the device number is 1, press the numeric button 1 and press SITE button again.
Note: The keyboard identifies the dome camera by SITE value, and the SITE value must be exactly the same with the
dome camera No..
3. Use the joystick to set the RS485 parameters.
Figure 3-5 Dome and Keyboard Connection
Figure 3-6 Turning the Key to MENU
Figure 3-7 Choose Mode as PTZ
16