Frigidaire FFGF3016TM Installation Instructions Manual page 4

INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE
Installation with cabinets
Check location where the range will
be installed for proper electric and
gas supply, and stability of the fl oor.
The dimensions shown here
must be used and are minimal
unless otherwise stated. These
measurements do not allow for any
clearance below the cooking top or
at the rear of the range.
Contact surface must be solid and
level.
Things to remember:
• Do not seal the range to side
cabinets.
• Do not pinch the power supply
cord between the range and
rear wall.
• If cabinet depth is greater than
25", the oven front frame must
extend beyond cabinet front by
1/2" minimum (See Fig. 1).
• All openings in the wall or
fl oor where the range is to be
installed must be sealed.
Installation beside wall
If installing beside a wall, the
minimum distance to combustible
wall on either side of range above
36" height should be according to
the BTU of the largest burner (See
Fig 2).
*
* 9500 BTU or less
10,000 - 16,999 BTU
17,000 BTU or greater
Fig. 2
Min. to cabinets on
either side of range
36"
Std.
Recommended area for thru
the fl oor connection of gas
pipe stub and shut-off valve.
2"
3"
5"
30"
13" Min. height from
Max. cooktop to cabinets
18"
30"
11-1/2"
10-1/2"
*15"
* Models without self-clean feature
may have an additional 7 inches
clearance from the fl oor.
Fig. 1
36±1/8"
(Adjustable)
29-7/8"
4
30"
23"
Recommended
area for 120V outlet
on rear of wall and
area for thru the
wall connection of
2"
pipe stub and shut-
off valve.
7"
30"
25-3/4"
29-1/4"
closed
46-5/8"
max
door
open
Fig. 3
25"
24"
48-1/2"
max
max
door