Technibel MRAF98R5I Series Operating Instructions Manual page 10

AIR FILTER
The filter behind thefront panel should be checked and
cleaned at least once every two weeks.
HOW TO REMOVE THE FILTER
EG
Front panel
1. Grasp both ends of the front panel and pull it towards you
and up.
2. Push the filter up slightly, and then pull it down. Clean the
air filter.
HOW TO REPLACE THE FILTER
Insert into the groove on the unit
1. With the «FRONT» mark facing you, slide the filter up
into the unit and then lower the handler into the groove
on the unit.
2. After installing the filter, press the locations marked by
the arrows ( ) and close the front panel .
FILTER CLEANING
Use a vacuum cleaner to remove light dust. If there is
sticky dust on the filter, wash the filter in lukewarm, soapy
water, rinse it in clean water, and dry it.
ACTIVATED CARBON AIR FILTER
(ACCESSORY SUPPLIED ON REQUEST)
The activated carbon air filter is to be added to the standard
filter.
It is made of two layers:
- the first layer consists in a synthetic honey comb high
efficiency media to remove the dust and purifing the
air.
- the second layer in charcoal media deodorizing the
ambient air.
NOTE
1.Two activated carbon air filters for one indoor unit are in
Air filter
this polyethylene bag.
2.Open the bag just before installing the activated carbon air
filters, if not the deodorizing effect durability of the filter may
be decreased.
This activated carbon air filter cannot remove harmful gases
Front panel
or vapors nor ventilate air in the room. You must open doors
or windows frequently when you use gas or oil heating
appliances. Otherwise there is a risk of suffocation in an
extreme case.
REPLACEMENT OF ACTIVATED CARBON AIR
Air filter
FILTER
The filter is disposable.
●
Do not throw away the filter frame.
●
● The used filter cannot be reused even after cleaning up.
Obtain the filters for replacement at your nearest dealer.
●
Check the state of dirtiness at least once every two
●
weeks.
Replace the filter after six months' operation.
●
ACTIVATED CARBON AIR FILTER INSTALLATION
PROCEDURE
The activated carbon air filter needs to be installed behind the
air filter.
1.Remove the air filter.
2.Install the air clean filter in the position shown in the figure
with the symbol "FRONT" facing you.
3.Reinstall the air filter.
Activated carbon
air filter
Front: white
Rear: black
Activated carbon
10
WARNING
air filter