Amplicomms Watch & Care V100 User Manual page 10

Table of Contents

Advertisement

P
G
UTTING THE
ERÄTE IN
Operation with rechargeable batteries
1. Turn the belt clip upwards.
2. Open the battery compartment on the rear side of the receiver.
3. Insert the batteries, paying attention to correct polarity.
4. Close the battery compartment again.
5. Turn the belt clip back downwards.
The receiver is powered by a a Lithium-ion battery pack of 3.7 V,
1800 mAh. The rechargeable battery pack can be recharged directly in
the receiver when it is inserted in the charging station. The Power LED
lights up red when the receiver is being charged. In the case of a low
battery charge, the Power LED flashes slowly. The battery pack must
then be recharged.
Using the belt clip/support
You can use the belt clip/support as a belt clip by turning it upwards.
When tuned downwards, it can be used as a support to keep it in a standing
position.
6
B
U
ETRIEB NEHMEN
NITS INTO
Helpline UK 0844 800 6503
(See page 18 for costs and hours of operation)
O
PERATION

Advertisement

Table of Contents
loading

Table of Contents