Remote control
The following table describes the functions for the Universal Remote control.
信号源 (SOURCE)
A
B
0~100+ channel selectors
音量 (VOL+ / VOL-)
C
UP/DOWN/LEFT/ RIGHT/ OK
D
静音 (MUTE)
E
暂停 (FREEZE)
F
显示 (DISPLAY)
G
画中画/画外画 (PIP/POP )
H
画中画/信号源 (PIP/SOUR)
I
画中画/位置 (PIP/POS)
J
ViewSonic
Select Input Source (e.g. Video, Antenna, PC).
Use these buttons to select a channel.
Adjust Volume.
UP/DOWN for OSD function select and LEFT/
RIGHT for function adjust. Press OK to confirm
buttons
your selection.
Temporarily switch off audio output retaining
the current volume settings.
Press this button to hold the current display.
Press again to release the picture. Note this is
not the same as pause and the underlying
broadcast continues.
Display the current input source and time.
Activate PIP feature (Activate Guide).
Press to toggle the Sub picture between PIP.
Change the display position of the Sub Picture
in PIP mode.
10
N4200w