Table of Contents
Advertisement
1. Remote control unit.
2. Sensor: Detects the room temperature around the remote
control unit, the air conditioner is controlled accordingly.
3. Receiver: This section picks up infrared signals from the
remote control unit (Transmitter).
4. Air outlet: Conditioned air is blown out of the air conditioner
through the air outlet (four flaps).
5. Air filter.
6. Suspension brackets.
7. Refrigerant couplings.
8. Condensate drain connection.
9. Electric junction box.
2
1
12 11
13
TIMER OPERATION
10. Operation selector.
ON Position:
In this position the air conditioner is operating
and controlled by the remote control unit.
Set the selector normally in this position.
OFF Position:
Switch the selector to the off position if you
are not going to use the air conditioner for
a few days or longer.
WARNING
The OFF position does not disconnect the power. Use the
main power switch to turn off power completely.
CAUTION
TEST Position:
This position is used only for servicing the
air conditioner, so don't leave the selector in
this position for normal operation.
11. Operation lamp: This lamp lights when the air conditioner is
running.
12. SERVICE lamp: When a fault occurs in the air conditioner, this
lamp turns on or flashes in combination with the other two
lamps to indicate the type of fault.
13. TIMER lamp: This lamp lights when the system is being
controlled by the timer.
MODELS DSAF
7
Advertisement
Table of Contents
