Osd Notice; Osd And Hot Keys Setting - ViewSonic VSD222C User Manual

6.5.3 OSD Notice

idling:
The OSD menu will close and go back to the original processing screen
automatically during your OSD menu is idling that reached to the OSD time
out value.
No signal:
• The connection for your D-Sub is not ready.
• The connection between D-Sub device and your smart display is not
normalization.

6.5.4 OSD and Hot keys setting

OSD Lock: Press and hold [
buttons are pressed the message OSD Locked will display for 3 seconds.
OSD Unlock: Press and hold [
seconds.
Power Button Lock: Press and hold [
seconds. If the power button is pressed the message Power Button Locked
will display for 3 seconds. With or without this setting, after a power failure,
your LCD display's power will automatically turn ON when power is restored.
Power Button Unlock: Press and hold [
for 10 seconds.
DDC/CI enable/disable: Press [ ] and [▼] keys at the same time to toggle
SSC/CI and DDC/2B (DDC/CI enable/disable) to allow the computer to send
specific Monitor Control Command Set (MCCS) to command the devices, as
well as receive sensor data from the devices, over a bidirectional link.
Logo Boot up screen ON/OFF: Press [ ] and [▼] keys at the same time to
allow for setting logo boot up screen or not.
Customizing Your VSD222C/VSD223 Smart Display
] and the up arrow [▲] for 10 seconds. If any
] and the up arrow [▲] again for 10
] and the down arrow [▼] for 10
] and the down arrow [▼] again
31