Quick Installation - ViewSonic EF70 User Manual

Quick Installation

1 Connect video cable
Make sure both the monitor and
computer are powered OFF. Connect
the video cable to the computer.
Macintosh
Macintosh adapter to the video
cable, then to the computer. To
order a ViewSonic
adapter, send an email to vsparts
E
@viewsonic.com or contact
N
ViewSonic (see the back cover of
G
this guide). You will need to provide
L
your monitor's serial number.
I
S
2 Connect power cord
H
Connect the power cord from a properly
grounded AC outlet to the monitor.
3 Power-ON monitor and computer
Power-ON the monitor, then power-
ON the computer. This sequence
(monitor before computer) is very
important.
NOTE: At this point Windows
users may receive a message asking
them to install the EF70's INF file.
4 Install INF and ICM files
• For CD-ROM: Insert the CD-ROM
into your system, wait for it to auto-
start, select "Monitor Drivers," and
follow the on-screen instructions.
• For diskette: Insert the diskette into
your system, run install.exe, and
follow the on-screen instructions.
Wall socket
Getting Started
6
® users: Connect a
®
Macintosh
®
98
Power cord
5 Windows users: Setting the
Timing Mode (
resolution and refresh
rate) Example: 1024x768@ 75Hz.
For instructions on changing the resolu-
tion and refresh rate, see the user
guide for your computer's graphics
card.
®
Use the OnView
6
adjust the screen image.
See the Operations section in this
guide.
Installation is complete!
Enjoy your new EF70 Monitor!
To be best prepared for any future
customer service needs:
• Write the serial number (see back
of the monitor) in "For your Records"
on page 1 of this guide.
• Register the warranty of your monitor
on the Internet at:
http://www.viewsonic.com
Video cable
controls to
ViewSonic EF70