Dmx512 Control; Remote Controller - Beamz BBP93 User Manual

DMX512 CONTROL

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until all units are connected.
CAUTION! At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.

REMOTE CONTROLLER

BLACK OUT Mode
Press <BLACK OUT> off existing modes. Press <BLACK OUT> return the last modes.
AUTO Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press <AUTO> on the remote controller.
2. Press <+> or <–> to choose between the different auto programs.
SOUND Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
1. Press <SOUND> on the remote controller.
2. Press <+> or <–> to choose between the different sound programs.
STROBE Mode
To adjust the strobe speed of the automatic program and the sound active program.
1. Press <STROBE> on the remote controller.
2. Press <+> or <–> to either increase or decrease the speed of the program.
3. Press <STROBE> again to turn off the strobe.
%
To activate the CC00 colour pulse mode:
1. Press <%> on the remote controller.
2. Press <+> or <–> to either increase or decrease the speed of the program.
MANUAL
To activate the AU01 auto program mode:
1. Press <MANUAL> on the remote controller.
2. Press <+> or <–> to choose between the different auto programs
FADE
To activate the EE00 colour gradual changing mode:
1. Press <FADE> on the remote controller.
2. Press <+> or <–> to either increase or decrease the speed of the program.
5
BLACK
AUTO SOUND
OUT
SENSI-
STROBE SPEED
TIVITY
%
FADE
MANUAL
R G B
A W
UV
+
0
1 2 3
4 5 6
7 8 9