Table of Contents
Advertisement
Care & Maintenance
- Power plug must be disconnected before cleaning and repair.
- Clean surface of the blender jar with a soft cloth or sponge. The measuring cup and the seal ring can
be detached for cleaning.
- The blender jar can be rinsed with water.
- The seal ring is detachable from the lid for easy cleaning.
- After cleaning, put the blender jar on its the side or upside down (Note 1) to dry * . Do not immerse
the whole jar in water.
*
To dry the blender jar in upside down position, remove the residual water with a dry cloth. Do not position near the sink or basin to avoid water spraying
to the bottom part of the jar. This may cause rusting of the bearing and thus affect the performance of the blender.
- Do not immerse the unit base or power cord into water or other liquids. Clean the unit base by soft cloth.
A Friendly Reminder :
To effectively remove dirt on the jar and blades and help them last longer, do the following: add in water
and lemon, close the lid and then press "Pulse " button for 2 to 3 times. Replace liquid with clean water
and repeat the above step.
Technical Specifications
Model No
Voltage / Frequency
Rated Power
Dimensions
Specifications are subject to change without prior notice.
If there is any inconsistency or ambiguity between the English version and the Chinese version, the Chinese version shall prevail.
Refer to www.germanpool.com for the most up-to-date version of the Operating Instructions.
PRO-L10 Limited Edition
220-240 V ~ 50-60 Hz
1,680 W
(H) 540 mm
(W) 220 mm
(D) 220 mm
P.10
Advertisement
Chapters
Table of Contents
