Table of Contents
Advertisement
Using the Rear Panel Configuration DIP Switches
Switch
Configuration Settings
DIP Switch 1- Output Mixing:
When DIP Switch 1 is OFF(default), each HD microphone has its own 3.5mm balanced audio output
on the Base Station. When DIP Switch 1 is switched on, the audio outputs of the two HD
microphones are mixed together and sent to both outputs.
DIP Switch 2 - Low Pass Filter:
When DIP switch 2 is OFF(default) the microphone provides the full audio bandwidth. When DIP
switch 2 is ON, a LPF is activated reducing the audio bandwidth.
DIP Switch 3 – Audio Output Level:
When DIP switch 3 is OFF(default) the microphone outputs provide a line level signal~0 dBu. When
DIP switch 3 is ON, the microphone outputs provide a mic level signal ~-40 dBu.
DIP Switch 4 - Mute Mode:
When DIP switch 4 is OFF(default) each microphone has its own individual muting capabilities. When
DIP switch 4 is ON, the microphone mute buttons are deactivated resulting in the mics always being
active and un-muted when not in the Charger Base.
DIP
Feature
1
Output Mixing
2
Low Pass Filter
Audio Output
3
Level
4
Mute Mode
5
Microphone EQ
6
7
Transmit Power
8
Off (Default)
Individual
Mixed Output
Outputs
No LPF
Line Level
Mic Level
Individual
No Mutes
Mutes
High
Bass
Flat
boost
Boost
Off
On
Off
Off
Off
On
150'
100'
50'
Off
On
Off
Off
Off
On
On
LPF
Dynamic
On
On
15'
On
On
11
Advertisement
Table of Contents
