Advertisement
Available languages
Available languages
Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• Plumber's putty
• Slotted screwdriver
• Pliers
• Adjustable wrench
• Cloth
Your installation may require new supply lines and / or shut-off valves or other
additional tools.
4
C
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Faucet
B Lift Rod
D Channel (2x)
E Sleeve (2x)
If any of these items are missing, please contact Price Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
• Phillips head screwdriver
• Flashlight
B
A
D
E
F
C Pop-Up Assembly
F Nut (2x)
ENGLISH
FAUCET INSTALLATION
5
5C
5D
5 FAUCET INSTALLATION
Place a bead of plumber's putty in the groove along the bottom outer edge of Bottom
Plate (5A). From above sink, insert Threaded Shanks (5B) and Faucet Inlets (5C)
through End Holes (5D) of sink.
6
6C
6A
6D
6B
6 SECURING FAUCET
From underneath sink, secure the faucet by placing the Channel Washers (6A) and Nuts
(6B) onto Mounting Posts (6C). Tighten Nuts (6B) until the faucet is firmly connected
to the sink. For thin deck installations, use the support Sleeves (6D) in addition to the
Channel Washers.
Caution: Do not over tighten!
2
BOTTOM GROOVE
5A
5B
5C
5D
5B
6C
6A
6D
6B
Advertisement
