Faucet Installation - Black & Decker Price Pfister 16 Series Manual

Thank you for purchasing this Price Pfister product. All Price Pfister products are
carefully engineered, and factory tested to provide long trouble-free use under
normal conditions. This product is easy to install using basic tools and our easy to
follow illustrated instructions. If you have any questions regarding this product, call
1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
WARNING
: To reduce risk of injury, Slide Bar must not be used as grab
bar or for support!
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
near the water meter. If you are replacing an existing faucet, remove the old faucet and
clean the surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE Plumber's Tape • Screwdriver
• Flashlight
Your installation may require new supply lines and / or shut-off valves or other additional
tools.

FAUCET INSTALLATION

4
4B
4C
4A
4 SHOWER DIVERTER INSTALLATION
Apply PTFE plumber's tape to all threaded ends of Shower Diverter (4A) and to the end
of Shower Arm (4B) according to manufacturer's instructions. Screw Shower Diverter
(4A) into the end of Shower Arm (4B). Make sure Rubber Seal (4C) is retained inside
Diverter Nut (4D).
• Adjustable wrench
• Cloth
4D
ENGLISH
5
5 SLIDE BAR INSTALLATION
Place Rubber Seal (5A) inside Slide Bar Fitting (5B). Screw Slide Bar Fitting (5B) into
Shower Diverter (5C) as shown.
6
6D
6C
6B
6B
6 WALL MOUNT LOCATION
The position of the Wall Mount can be adjusted along Slide Bar (6A) by removing Shells
(6B), Screws (6C) and Clamp (6D). Locate a desired position and re-install Shells (6B),
Screws (6D) and Clamp (6D) onto Slide Bar (6A).
2
5C
5A
5B
6B
6A
6B