AEG LAVAMAT W 857 User Information page 31

Problem
Washing is not
thoroughly spun,
water remains visi-
ble in the drum.
The L (END) light
flashes twice an
acoustic signal is
emitted twice.
The door cannot be
opened when the
washing machine
is on.
O/s (START/
PAUSE) and
K (DOOR) lights
come on.
Power failure dur-
ing a wash pro-
gramme (all
indicator lights
are off).
Possible cause
The drain hose is kinked.
The maximum pump height
(outlet height 1 m from
the base of the appliance)
is exceeded.
The drain pump is blocked.
For siphon attachments:
the siphon is blocked.
Door is locked due to high
water level, or high tempera-
ture.
The failure may be caused by
a blown house fuse or by a
mains supply fault into the
house.
(For safety reasons, the door
remains locked for around
2 minutes.)
Operating Instructions
Remedy
Remove the kink.
Contact your local Service
Force Centre. For pumping
heights over 1 m a conversion
kit is available as a special ac-
cessory.
Switch off the machine and
disconnect the mains plug.
Clean the drain pump.
Clean the siphon.
Wait until the programme has
ended, the K (DOOR) light
goes off and the L (END)
light is lit.
If it is necessary to open the
door immediately,
Turn the programme selector
to I (OFF); then turn it to
v (DRAIN). Press the O/s
(START/PAUSE) button.
When the water has been
pumped out, the door can be
opened.
The programme continues
when power is restored.
If washing has to be taken out
during a power cut:
Turn the control knob to
I (OFF).
Carry out emergency emptying
(see Section "Carry out emer-
gency emptying").
After about 2 minutes,
the door can be opened by
pulling on the handle.
31