Using The Remote Control - Prem-I-Air EH1442 Manual

target temperature. The thermometer symbol will illuminate,
and the digital display will flash, showing the target
temperature. After 5 seconds the display will stop flashing
and return to displaying the room temperature.
To set the timer press the TIMER button. The clock symbol
will illuminate. Then use the up- and down-arrow buttons to
set the number of hours for which the heater is to run before
automatically switching off.
Unplug the appliance from the mains when not in use. The
cable can be wrapped around the plastic cable tidy on the
front panel.

USING THE REMOTE CONTROL

The remote control duplicates all the controls that are on the
control panel.
The digital display will display the
room temperature.
The up- and down-arrow buttons can
be used to select full power or half
power. This is indicated by
segments to the right of the flame
symbol. Small segment lit = half
power. Both segments lit = full power.
To set the thermostat press the
TEMP button, then press the up- or
down-arrow buttons to change the
Page 3
the