Advertisement
INTERRUPTING A PROGRAM
In order to interrupt a running program it is necessary:
TO CHANGE A PROGRAM
To change the running program it is necessary:
STOPPING A PROGRAM
To cancel a program which is running:
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will
start about 60 seconds later.
16
User instructions
to press the START/PAUSE
led START/PAUSE remains lit on (confirmation beep). At this point,
it is possible to start the cycle again, otherwise:
to interrupt the running program (see "I
select the new program;
to press again the START/PAUSE button
program.
Interrupt the program (see "
Press the START/PAUSE button
display will show "P0" and the dishwasher will immediately
switch to the end of the cycle and drain the tank (during this
process, the "START/PAUSE led will flash). When the drain
procedure ends, the end of cycle "End" message appears on
the display.
S
TARTING THE PROGRAM
for some seconds until when the
NTERRUPTING A PROGRAM
to make start the new
INTERRUPTING A PROGRAM
and hold it down; the
". The program will resume from the
");
")
Advertisement
