Storage> Ftp Server - Cisco Linksys WRT610N User Manual

Chapter 3
Storage > FTP Server
An external USB hard drive or USB disk must be connected
to the USB Port of the Router to use the storage feature.
The FTP Server tab creates an FTP Server that can be
accessed from the Internet or your local network.
Storage> FTP Server
Setup
Server Name
The name of the Router's FTP server
is displayed here. It can be changed on the Storage >
Administration screen.
FTP Server Select Enabled to set this Router as an FTP
Server. Otherwise, select Disabled to turn the service off.
An external USB hard drive or USB disk must be connected
to the USB Port to use this service.
Internet Access Select Enabled to allow access of the
FTP Server from the Internet. Otherwise, select Disabled
to only allow local network access.
FTP Port
Enter the FTP Port number to use. The default
port is 21.
Access
This section lets you add FTP folders that can be accessed
through the FTP client. Click Specify Folder to Access to
add a FTP folder to the Access table.
If you click Specify Folder to Access, the FTP Folder screen
appears.
FTP Folder Screen
Use this screen to add an FTP folder.
Simultaneous Dual-N Band Wireless Router
Advanced Configuration
FTP Folder Screen
Display Name
Enter a display name that will appear in
the Access table of the FTP Server screen.
Partion The name of the Partion to share, that you
selected in the Shared Folder will appear here.
Location
The location of the shared folder is displayed.
New Folder
To create a new folder, enter a name for the
folder and click Create.
Share entire Partion To share the entire partition, click
the check box for Share entire Partion.
If you don't want to share the entire partition, you can
specify the folder you do want to share. Select a folder
name to share. To see a sub-folder, click Enter into Folder.
To return to the previous folder, click Return to Upper
Folder. To create a new folder, enter a name in the New
Folder field, then click Create.
Access Select the right Access arrows to allow access to
a group or the left arrows to remove access to a group.
You can allow Read and Write or Read Only access. To add
more groups, go to the Storage > Administration screen.
Click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes. Click Close to close the
screen.
Each Display Name you created on the FTP Folder screen
will be listed with its partition and folder, which you can
edit or delete. Select Edit to edit an item or Delete to
delete the item.
21