Error Messages - LG MFL69482503 Owner's Manual

Error Messages

Symptoms
34
Reason
Drawer is not closed properly
Door is not closed properly
Water supply taps are not fully
open.
Water line hoses are kinked,
pinched, or crushed.
Water inlet filters are clogged.
Water supply pressure to tap or
house is too low.
Water supply connected with
leak-limiting hoses.
Drain hose is kinked, pinched,
or clogged
Drain discharge is more than
1.2 m above bottom of washing
machine.
Solution
• Close the drawer and press Start/Pause
button to start the cycle.
• If the drawer is closed and the drawer lock
error message is displayed, call for service.
• Open the drawer and make sure the latch
area is free of clothing or other obstructions.
• Close the door, shut the drawer, and press
Start/Pause to start the cycle.
• If the door is closed and the door error
message is displayed, call for service.
• Make sure that the water taps are fully open.
• Make sure that the hoses are not kinked
or pinched. Be careful when moving the
washing machine during cleaning and
maintenance.
• Clean the inlet filters.
• Check another tap in the house to make sure
that household water pressure is adequate
and flow is not restricted. Disconnect the
supply hose from the washing machine and
run a few liters of water through the hose to
flush the water supply lines. If flow is too low,
contact a plumber to have the water lines
repaired.
• Hoses designed to limit leaks can trip falsely
and prevent the washing machine from
filling. The use of leak limiting hoses is not
recommended.
• Make sure the drain hose is free of clogs,
kinks, etc., and is not pinched behind or
under the washing machine.
• Adjust or repair drain. Maximum drain height
is 1.2 m.
EN