Installing And Removing Memory Expansion; Removing The Cover - Fujitsu LIFEBOOK AH552 Operating Manual

Removing and installing components during servicing

Installing and removing memory expansion

System expansion System expansion Removing memory Mainmemory Memorymodule
If you are asked by the Hotline/Service Desk to remove and install the memory
expansion yourself, proceed as follows:
Please observe the safety information in chapter
The notebook must not be connected to the power supply during installation or removal
of memory modules, see
Only use memory expansion modules that have been approved for your
notebook (see
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the memory extension compartment.
You must open the service compartment to remove or install a memory module. On some devices,
opening the compartment may expose other components. These components should be removed
and replaced only by authorised specialists. Therefore, be sure to observe the following:
Individual components can become very hot during operation. Therefore, we
recommend that you wait one hour after switching off the notebook before removing
or installing memory modules. Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please take
note of chapter

Removing the cover

► Remove the screws (1).
► Lift the cover off the notebook (2).
46
"Preparing to remove components", Page
"Technical data", Page
"Notes on installing and removing boards and components", Page
1
"Important notes", Page
63).
1
1
1
2
1
12.
45.
1
Fujitsu
44.