Bbg-1040-Aco Unit Dimensions; Rear Panel Connections - Cobalt Digital Inc BBG-1040-ACO Product Manual

2
Note: BBG-1040 will not align with tray captive
fastener if rubber feet are affixed to
bottom of BBG-1040.
Remove rubber feet if BBG-1040 is
being installed in tray.

BBG-1040-ACO Unit Dimensions

Rear Panel Connections

2-2
From front of tray, slide unit into tray, aligning with
1
tray edge and/or guides
2
Figure 2-1 Mounting BBG-1040-ACO Using Frame Mounting Tray
Figure 2-2 shows the BBG-1040-ACO physical dimensions and mounting
details for cases where BBG-1040-ACO will be installed in a location not
using the optional
Perform rear panel cable connections as shown in Figure 2-3.
Note: • The BBG-1040-ACO BNC inputs are internally 75-ohm terminated. It is not
necessary to terminate unused BNC video inputs or outputs.
• External frame sync reference signal (if used) must be terminated if a
looping (daisy-chain) connection is not used. Unterminated reference
connection can result in unstable reference operation.
BBG-1040-ACO PRODUCT MANUAL
Slide unit (rear) fully to rear of tray. Secure unit to
tray using captive fastener. Tighten only finger tight.
BBG-1000-TRAY
Rear Panel Connections
mounting tray.
BBG1040ACO-OM (V1.4)