SkyLink CSL-2 User Instructions

GARAGE DOOR REMOTE CONTROL
USER'S INSTRUCTIONS
(MODEL : CSL-2)
PROGRAMMING YOUR NEW TRANSMITTER
1. Open the case with a corn.
2. For code setting:
With the receiver unit plugged in the AC outlet, press and hold the 'learn' button
on the receiver and its LED light will flash. Then press the button on the
transmitter until the receiver light stops flashing indicating it has learned the code.
3. Test the receiver unit with the transmitter.
LIGHT
Press the case to emit the light.
BATTERY
One 3 volt Lithium type (CR2032) battery included.
WARNING
If this transmitter triggers other garage doors in your neighborhood, change all your
transmitters and receiver to a new code setting.
DO NOT let children use the
garage door transmitter
without adult supervision.
Children can injure
themselves or others by the
garage door.
WARRANTY
If, within one year from date of purchase, this product should become defective (except
battery), due to faulty workmanship or materials, it will be repaired or replaced, without
charge. Proof of purchase is required.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed