Table of Contents
Advertisement
2-4
Connect the center rod to the damper receiver.
* This operation must be carried out on both low and high register sides.
2-4-1
Loosen the center rod wing bolts (two locations) and insert the center rod into the pedal
rod.
Center rod wing bolt
2-4-2
While supporting the damper receiver with your hand, insert the end of the center rod
into damper receiver.
2-4-3
Tighten the lock nut on the center rod to secure.
* When the nut becomes loose, or when the lock nut is set too high, the lock nut spring will be loose.
This can be a source of noise so take care and adjust properly.
Center rod
Center rod wing bolt
Pedal rod
Damper receiver
The illustration shows the
attachment looking from the
high register side.
Center rod
Lock nut
Lock nut spring
Assembly
21
Advertisement
Table of Contents
