Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sepura SER8010
Summary of Contents for Sepura SER8010
- Page 1 Installation and Operation Guide DMR Repeater For SBR8000 / SCR8000 / SER8000...
-
Page 3: Table Of Contents
SPR-DOC-03800/2 Original Instructions: ENGLISH All rights reserved. This document is intended for the use of Sepura plc’s customers and/or other parties only for the purposes of the agreement or arrangement under which this document is submitted, and no part of it may be reproduced or transmitted in any form or means without the prior written permission of Sepura plc. -
Page 4: Safety
Accessories Regulatory section of the product user guide. Sepura products have been tested to meet strict guidelines for Unauthorised modifications to the product could cause the personal safety and operational conditions. Only accessories product to become non-operational. -
Page 5: Regulatory
Contact your service This radio is intended for use in occupational/controlled provider or Sepura for information about disposing of this applications where users have been made aware of the potential product in your region of the world. -
Page 6: Repeater Technical Specifications
located or operating in conjunction with any other antenna or Repeater technical specifications transmitter. Frequency Range: The antenna should be installed and operated with a minimum VHF............... 136-174 MHz distance of 1.2m to any person. UHF ..............400-470 MHz Cette radio a été conçue pour un usage professionnel dans un Dimensions (WxDxH) ..... -
Page 7: Duplexer Technical Specifications
Duplexer technical specifications An optional duplexer can be used with the repeater. The duplexer allows the repeater’s receiver and transmitter to operate on a single antenna at the same time. When operating within neighbourhoods where other RF devices are installed, including broadcast antennas and microwave link transmitters, the duplexer prevents interference with other RF devices. - Page 8 Front Panel Rear Panel DMR Repeater SBR8000, SCR8000, SER8000...
-
Page 9: Controls, Connectors And Components
Controls, connectors and components Status indicators Refer to the illustration for the location of the following controls, The LEDs on the front panel indicate various operational states. connectors and buttons. (1) Handles (2) Status indicators (3) Power switch (4) GPS antenna connector Description (5) Accessory connector TX-A... -
Page 10: Unpacking
Unpacking Accessory information Sepura supply a range of accessories for this product. Contact your service provider or visit the Sepura website for a full list of accessories. Accessory Part No. Wall mount bracket 300-01071 AC Power cable (UK) 300-01139... - Page 11 It is recommended that when wall mounted, it must be The wall-mount bracket is supplied with the following items: positioned so that it is clearly visible to personnel to reduce the Item risk of personal injury by collision. Ensure sufficient air flow to prevent overheating.
-
Page 12: Connections
Connections All connectors are located on the back panel of the repeater. Ensure that the cables are routed so that they are kept well clear of the antenna cable. Route cables carefully to eliminate the possibility of damage by sharp edges. Ensure all cabling is secured and routed to avoid the risk of a trip hazard. -
Page 13: Basic Operation
Basic operation Caution: Failure to connect the wires to the correct terminal of the battery or power supply may damage the product and Power on/off void any warranty. To power on, operate the Power on/off switch. The Power on/off DO NOT extend the Repeater Battery Backup cable. This will status indicator illuminates and the repeater runs a start-up test affect the backup operation. -
Page 14: Configuring The Repeater
Configuring the Repeater Alarm mode The Alarm indicator on the front panel illuminates when certain The repeater is configured using the DMR Manager software operational states warrant. When the repeater is in start-up run from a computer connected directly to the repeater or over a mode, the LED remains illuminated for the duration of the start- network. - Page 15 Sepura plc Radio House St Andrew's Road Cambridge CB4 1GR Tel: +44 (0)1223 876000 sepura.com Fax:+44 (0)1223 879000...
Need help?
Do you have a question about the SER8010 and is the answer not in the manual?
Questions and answers