SPR-DOC-03800/2 Original Instructions: ENGLISH All rights reserved. This document is intended for the use of Sepura plc’s customers and/or other parties only for the purposes of the agreement or arrangement under which this document is submitted, and no part of it may be reproduced or transmitted in any form or means without the prior written permission of Sepura plc.
Accessories Regulatory section of the product user guide. Sepura products have been tested to meet strict guidelines for Unauthorised modifications to the product could cause the personal safety and operational conditions. Only accessories product to become non-operational.
Contact your service This radio is intended for use in occupational/controlled provider or Sepura for information about disposing of this applications where users have been made aware of the potential product in your region of the world.
Working temperature range....-30 to 60 C (-22 to 140 Transmitter Power Output: 25W/40W ............400-470 MHz 25W/45W ............136-174 MHz For more technical information about this product, refer to the product technical datasheet available from our website. DMR Repeater SBR8000, SCR8000, SER8000...
Duplexer technical specifications An optional duplexer can be used with the repeater. The duplexer allows the repeater’s receiver and transmitter to operate on a single antenna at the same time. When operating within neighbourhoods where other RF devices are installed, including broadcast antennas and microwave link transmitters, the duplexer prevents interference with other RF devices.
Controls, connectors and components Status indicators Refer to the illustration for the location of the following controls, The LEDs on the front panel indicate various operational states. connectors and buttons. (1) Handles (2) Status indicators (3) Power switch (4) GPS antenna connector Description (5) Accessory connector TX-A...
Unpacking Accessory information Sepura supply a range of accessories for this product. Contact your service provider or visit the Sepura website for a full list of accessories. Accessory Part No. Wall mount bracket 300-01071 AC Power cable (UK) 300-01139...
Page 11
It is recommended that when wall mounted, it must be The wall-mount bracket is supplied with the following items: positioned so that it is clearly visible to personnel to reduce the Item risk of personal injury by collision. Ensure sufficient air flow to prevent overheating.
(red wire) when the cable has been shortened. A new fuse holder must be fitted (not supplied) because the existing fuse holder cannot be reused. The fuse must be positioned close to the DC power source positive terminal. DMR Repeater SBR8000, SCR8000, SER8000...
Basic operation Caution: Failure to connect the wires to the correct terminal of the battery or power supply may damage the product and Power on/off void any warranty. To power on, operate the Power on/off switch. The Power on/off DO NOT extend the Repeater Battery Backup cable. This will status indicator illuminates and the repeater runs a start-up test affect the backup operation.
Flashing every two Tx PLL failure. Clean the exterior surfaces using a lint free soft cloth. seconds Check cable connections regularly to ensure that they are secure. DMR Repeater SBR8000, SCR8000, SER8000...
Page 15
Sepura plc Radio House St Andrew's Road Cambridge CB4 1GR Tel: +44 (0)1223 876000 sepura.com Fax:+44 (0)1223 879000...
Need help?
Do you have a question about the SCR8000 and is the answer not in the manual?
Questions and answers